Recommended annually to keep slide out rooms operating smooth. Lubricate tracks and gear slide mechanism; treat the rubber bulb seals and wipers; inspect slide out alignment, toppers, and seals. Single Slide to Full Slide Room Maintenance available.
Top off fluids, clean terminals and posts, test amps/volts, and apply anti-corrosive (up to six batteries).
Perform annually for operating safety and fuel efficiency. Clean main burner orifice; clean blower wheel; clean/Inspect/Adjust electrode assembly; test module board/inspect and clean board contacts; clean and inspect combustion chamber; inspect fan motor; clean and inspect vent tubes and outer casing; reassemble furnace using new gaskets.
Recommended annually for operating safety and fuel efficiency. Check condition of anode rod; check relief valve; adjust burners and electrodes; check thermocouple; check module board; check complete operation; check burner assembly remove nests, bugs, webs, etc.
Recommended annually to maintain trouble-free operation and long life. Verify unit is airtight in the compartment; refrigerator is properly vented (roof and sidewall); clean and adjust burner and orifice; inspect and test all door seals; check LP pressure and proper voltage; clean roof vent and check baffle.
Manufacturers recommend this service every 75 operating hours or 12 months to maintain trouble-free operation and long life. Change oil and filter; service includes required oil and filter. If needed, generator removal and any additional parts will be an extra charge.
Drain fresh water tank and water heater, fill P-Traps with anti-freeze; pump antifreeze through water lines with water heater bypass already installed; includes up to 2 gallons of antifreeze.
Drain antifreeze, flush out any antifreeze in drain lines, sanitize fresh water holding tank and water heater tank (this is a two-day process), check anode rod for corrosion, check water filter if installed.
Perform every 6 months to prevent electrical failures and maintain safe operation. 12 volt - all lights, monitor panel, 110-Volt system polarity, hot skin test, converter operation and output, shore cord and circuit breakers and generator operation and output.
Manufacturers recommend this service annually. Clean roof with specially designed cleaning agents and apply UV-Blocking treatment to protect the roof.
Recommended annually to improve performance and operating efficiency. Examine shroud for cracks and damage; check compressor voltage; check compressor amperage; remove and clean A/C filter; clean and unclog A/C roof drains; check air temperature drop across the evaporator coil.
Recommended annually to flush out the black tank to remove the nasty that has been built up over the season.